The theory behind the zebra stripe design

I have been asked a few times if the airbrush artist came up with the design of the zebra stripes. I replied no, it was mine hence was not charged for the design work merely having it transferred to the motorcycle. How I came up with that unique design? I surfed at pictures of zebras and realized no two zebras have the same stripe design just like the whorls on our finger print, even the stripes on one side do not repeat itself on the other side of the zebra.

1. Firstly, the width of the stripes was to be 7 stripes on the side of the tank  to make them stand out. I also made each stripe look different.
2. The original design did not work as plan because when the stripes hugged the tank, they crisscross thus were adjusted on the tank itself.
3. By coincidence, on the tank was the face of a Zulu warrior with black war stripes over his eyes and cheeks.
4. As for the fenders, inverted triangle stripe was placed where the frame meet the fender based as found at the leg joint of zebras to their body. This meant concave shape stripes would be drawn away from that triangle.
5. The front fender has to have the stripes pointed out like the horn of a unicorn so turned around the stripe design normally found at the back of a zebra whereas the rear fender would have the stripes drawn like a normal zebra.

I am no artist but was very pleased with the results. My helmet was also another difficult exercise because I wanted the stripes to 'flow with the wind' and felt it was harder to design that than the stripes on the bobber.

 

Cleaning the engine, the lazy way

I have successfully been doing this for more than 30 years and is the technique I keep the engine bay of my cars, (previous till current) looking showroom condition. It's also the lazy man's but clever way of maintaining the cable/wire insulators and rubber components from being dry and brittle due to engine heat. It is also because of this, I do not wash nor allow the engine bay to be washed at car wash places for fear water may seep into the spark plug connectors (and has been before). I can but usually do not wipe it. Now, I do it to my bobber. The technique? Just buy an anti-rust spray can. Spray liberally then let it dry. That's all. I tend to do it in the night because I want the spray to permeate into the plastic and rubber components. However, in the case of the motorcycle, I spray water over the whole motorcycle once a while especially after riding on a rainy day then I respray the engine again with the anti rust oil. This photo shows a bit of glare from the chrome parts because they came into contact with anti rust oil. Having said all this, if you regularly ride in dusty areas, this technique may not be so good as it attracts dust and dirt so a thorough wipe is recommended after the spray has dried up.